Ive recently replaced my screenwash motors, and about a week later the two front jets, since fitting these jets I've got no pressure in them, the water just trickles out. (doesn't even reach the windscreen one side!) The rear still jets out, so motors ok, and ive tried removing any posible airlocks, with no sucess. Any ideas for fixing this please?

if it's a gen 1 the front and rear washer motors are different, often gunk in the mesh at the opening of the washer motor causes poor performance

The motors are brand new, only had them fitted a couple of weeks, shouldn't be them

I did mine with warm water and a length of hose. Fill near to the top, insert hose, blow to agitate the crap at the bottom of the tank and then siphon out into a bucket. Loads of crap someones out. Oh and if there is a sponge in the tank get it out. I pulled mine out a couple of weeks ago and it was pink with a hint of black mold....

guys, where exactly is the front washer bottle motor located for the front washer jets, seems it would be down beside the motor...but around that are is all sealed up if im not mistaken?

The pumps are in the bottom of the bottle (sort of) for both front and back

anyone an idea of cost of a num motor, and they do sell pattern parts/replicas? rather than original hyundai stuff

surley you had to remove the arch liner thought, which id rather not to as the clips always break

the headlights and indicator comes out quicker than a arch liner, let me tell ya