Fitted Ark Lightweight pulley set today. Easy fit just matching up the right size belts a pain in the arse. From the off i dont notice much difference but they really kick in on the mid range speeds

Wow they look great mate ... makes the engine look like new
BTW i've edited your post from " Pain in the bum " to what it is now ... i dont mind light swearing , its just heavy stuff or every other word

not worth it yet may as well finish first,pulleys dont give extra power just free up a bit at wheels

You will need two belts for the pulleys as the UD pulleys a hell a lot smaller than stock. Coupe stores say you only need one belt but i say you defo need two. Use QH Automotive Belts... part number QBR4850 (31.75") for UD to Water to Alternater Pulleys & part number QBR4813 (31.25") for UD to Air Con pulleys (please note 2L gen 3 3.5 & SIII sizes only). Big Shout out to KARPARTS ltd Aldridge for the help with belts.. Hope this information helps you guys

Earlier i wrote that i fitted FUJITA CAI but it wasn't the best fit. Anyway i had the day off & ripped it out & started again, it was a real bitch to get it right & i had to enlarge to hole a bit where the pipe passes through to cone filter. The FUJITA now fits perfectly & is real sturdy fit, also had a couple of hours of daylight left so stuck the engine damper in. I recon i've saved my self a few qid fitting all this stuff the past couple of days, garages just rip you of & do a turd job over half the time