A couple of pics from various stages of mods


Half the Cadamuro Design body kit installed (replacement bonnet, (not just the vent kit) and front bumper) still have side skirts to fit and rear lip to secure





pretty much how the car is at the moment. Not sure anymore about the graphics....seemed like a good idea at the time....and I'm half convinced they've put the vents on inside out! I thought they should have been flush with the body line

Shogun Rear Spoiler? You mean like this one?



or even better, like this one?

either that style or this one (might be the same just from a different angle

only difference (I think) is that I have the third brake light and that doesn't

Nice car Arfon, like that kit and the various pieces ..............

...I agree with the side vents - they do take away from the look of the car !

But white is a GREAT colour on a coupe !

Nice work bud

yeah, I'd hoped the vents would have come out like this (a bit like Xorro's)



Yeah I was thinking of getting the wing with a brake light, but then I've already got one on the top spoiler, so I'd have 4 - hehe, people would have no excuse for running into the back of me with 4 brake lights!

other mods include fitting the rear part of kit, and tint film on the small back windows, you can only tell from the inside that its a DIY jobby, but not many people sit in the back to notice!

also put a ripspeed universal cone filter as replacement to standard box, strut brace at the front, CD player and 10disc changer, fusion 12" sub and amp pack, clear indicators and clear bulbs on front lights.

I did have Lexus rear's but after I lost the receipt I noticed the Fog lights were constantly on (missing metal connector in the pin socket) so have had to revert to standard.

Alloys are 17" MOMO Fighter's, and it hasn't been lowered... only needed spacers

Oh and I did have under car multi colour LEDs but the connectors wore and so only a few of the lights light up

rear part of bodykit (lower /exhaust surround) looks like this



the slots fit around the standard exhaust tip configuration, so its possible to get 4" ovals. Powerflow distributor in Deeside when I showed them the pic thought they were the smaller exits.

side skirts also need fitting and I've tried tried and tried to get them off, but the screws are either too tight or the heads too far worn, Plus I have limited access to under the car being on a cul de sac.

Provided there's no essential bodywork blocking access, but see where the indent is in the side skirts by the back wheels, I'm wondering whether there's scope of an exhaust exit on either side, like this (very!) rough sketch (looks like the broomsticks in Sorcerer's Apprentice!)



although I note from other posts that even twin exits drops power so it might not be worth it, even if structurally possible