well iv swapped my seats!VERY EASY TOO.but a bit of a drama with air bags.
The back seats are very easy to do just drop the backs lift the bottom trim(held with velcro)and undo bolts.pull off.
next undo 2 bolts holding the lower base in place.and then go round the front and push the tiny clips forward.out it comes.

front seats are just four bolts then unplug airbags beneath.
here's where trouble starts.
the plugs on 3.5 are different to 3.i asked on new tib only to be told only way round it is to strip cover off old seats and recover dont pull airbags or cut wires or they will go off.
ALL TOTAL CRAP.
if you unplug they dont go off.airbag light comes on and if you leaveunplugged stays on.you need to swap your seatbelt holder-one bolt-to your new seats cos old one has 3 wires new one 2.
cut the other plug and replace with a gen3.5 wire solder the two wires and its done.air bag light may or may not need resetting.but sharky tells me he's soldered loads and airbag wont go off.so now im sitting pretty with working airbags and new seats.il post pics tomorrow

thanks to sharky.again,he is the man

But how do you know there working ... have you had a bump daz

looks just like a 1.6!!!

haha its amazing the silly little things they changed in the gen3 to 3.5 like the seats, which look the same only with fancy stitching! glad u got sorted. u pleased with them?

the coupe self tests its own airbags by sending a current down the line apparantly hence the airbag warning light goes out

my bottom needs a kiss scouty ask mr faz-although not up to v6 standards its going really well

daytime pic

They actually look surprisingly good in there mate !

yep they suit it down to the ground

they look awesome mate, dont look as pink in the daytime pic though haha

thats right enough they look alot redder than i imagined

dont get backing down now,you saw yourself its going much better than it was