Got my new window motor from korea today, happy days, its works fine. but when we have gone to connect it up we cannot get the tension/lax correct, the tensioner is fine, but then the other peice wont clip into the plastic. now is this just a case of perseverance or are we doing something wrong or stupid??? and when we thought we would test the motor quickly, it chewed the wire, so gott ablow torch heat it to straighten it out again. been in garage for 4hours solid, and nothing, taking it off re-adjust, back on and still not right. anyone done theirs? any help info would be great!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Only advice iv seen that might be helpful is to work with the window wound down but iv not had a proper look behind the bluetacked plastic sheet. Just put mine in under warranty, hoping they just do the work and not try screw me out of hundreds of pounds for pish poor work

Try