have just ordered a replacement hub and bearing kit for my gen 1....before i install can anyone advise on how much of a bitch this is going to be to fit

the bearings I assume are for the back SO they'll be easy enough to do, they just slide on and off (pretty much lol) I know we swapped my rear bearing when I had hubs on the back in about fifteen minutes, the hubs will tkae you a bit longer to do but shouldn't be too bad a job ...

if you had discs on the back then the bearing would be a pain to do (I've done mine many times lol) as you have to have the bearing pressed in, but not a problem with hubs

just give it a day mate, best thing to do

yea i have disc brakes and was gonna allow atleast a couple of hours...screw it i done the gear box so this should be a walk in the park

I've done the job twice bud, you have get that bearin in flat, I'd get a garage to do it if you can afford it as it really is a bitch of a job to do yourself

piece o pie mate.
14mm spanner off with the caliper big hub nut in the middle 32mm36mm? cant rem. disc off .
and reverse .
20mins. if you've done the gearbox you'll sinch this.

how awkward are they to get back on! saying that i did it on an unlevel drive on my own but meh!

johny

cheers guys, it'll give me somethin to think about over the christmas period

its very easy

20 mins wam bam thank you mam...piece of urine